5/28/2023 0 Comments Raspbian samba smbconf![]() You can list all of the mount points on your Mac using the df command: $ df In the example above, the pi volume is listed. You can see the new mount point using the ls command: $ ls /Volumes/ When you connect using Finder, by default it adds the mount point to the /Volumes folder. In this step I'm going to show you some of the ways that you can access the remote volume using the command line. You can do that either through Finder or from the command line. You should now be able to access and transfer files to and from the Pi from your Mac. The new volume should now appear in Finder where you can see the test file. For volume selection, you may have only one option ( pi).When prompted, remember to enter your Pi username (i.e.Enter this address (substituting pi4 for for your pi hostname):. ![]() Select from the main menu Go / Connect to Server.Later I will show you how to connect using the command line. Connect to the Pi via Finder (Mac)įirst I'm going to show you how to connect to the remote Pi on a Mac using Finder. Once a remote connection is setup, you can look for this file to verify that you have access. Restart the Samba server using this command: $ sudo /etc/init.d/smbd restartĬheck the status to confirm that there wasn't an issue with the config file: $ sudo /etc/init.d/smbd statusĬreate a test file on your Raspberry Pi: $ echo 'This is a test.' > ~/test.txtĬonfirm that the file was created: $ cat ~/test.txt Create a Samba passwordĬreate a Samba password for remote access as user pi: $ sudo smbpasswd -a pi To configure Samba for read and write access, open up its configuration file using the nano text editor: $ sudo nano /etc/samba/smb.confįind the line that says read only and set it equal to no. Configure Samba for read and write access Status: "smbd: ready to serve connections." Look for lines like this to confirm that things are working: Active: active (running) since (DATE) 3min 21s ago Modify smb.conf to use WINS settings from DHCP?Ĭheck the status of the service to confirm that it was installed and is working: $ sudo /etc/init.d/smbd status You may get prompted with a dialog box that asks: Run this command to install Samba: $ sudo apt-get install samba samba-common-bin Get the latest updates by running this command: $ sudo apt-get update Remote login to the Raspberry Pi over ssh or open up a terminal window via the desktop. This article covers how to transfer and access remote files on a Raspberry Pi using Samba.
0 Comments
Leave a Reply. |